Good Quality Coil Nailer - Pneumatic High Quality Coil Nailer – Union

features

1.Industrial grade,powerful for heavy duty applications.
2.High durability driver and bumper for long life.
3.Rapid firing design,high speed operation.

application

Used for Pallets,Boxes and crates,Fencing,Packaging,etc.

applicable Industry Categoty

Mattress,Fence,Pet cage,Farming cage,Wire net,Large furniture,
Upholstery,Shoes Making,etc

parameter

instructions for operation

1.OPERATION Wear safety glasses or goggles danger to the eyes always exists due to the possibility of dust being blown up by the exhausted air or of a fastener flying up due to the improper handling of the tool. For these reasons,safety glasses or goggles shall always be worn when operating the tool.The employer and/or user must ensure that proper eye protection is worn.Eye protection equipment must conform to the requirements of the American National Standards Institute,ANSIZ87.1(Council Directive 89/686/EEC of 21 DEC.1989) and provide both frontal and side protection. The employer is responsible to enforce the use of eye protection equipment by the tool operator and all other personnel in the work area. NOTE:Non-side shielded spectacles and face shields alone do not provide adequate protection. Keep hands and body away form the discharge outlet when driving the fasteners because of dangerous of hitting the hands or body by mistake. 2.NAIL LOADING (1)Open the magazine Pull down door latch and swing door open.Swing magazine cove open. (2)Check adjustment The nail support can be moved up and down to four settings.To change setting pull up on the post and twist to the correct step. The nail support should be adjusted correctly to the position indicated in inches and millimeters inside magazine. (3)Nail loading Place a coil of nails over the post in the magazine. Uncoil enough nails to reach the feed pawl, and place the second nail between the teeth on the feed pawl. The nail heads fit in slot on muzzle. (4)Swing cover closed. Close the door. Check that latch engages.(If it dose not engage, check that the nail heads are in the slot on the muzzle). 3.TEST OPERATION Adjust the air pressure at 70p.s.i(5 bar) and connect the air supply. Without touching the trigger, depress the safety against the work-piece.Pull the trigger. With the tool off the work-piece,pull the trigger.Then depress the safety against the work-piece.(The tool must fire the fastener.) Adjust the sir pressure as much as the lowest possible according to the diameters and length of fastener and the hardness of work-piece.

operation

The common operating procedure on〝Contact Trip〞tools is for the operator to contact the work to actuate the trip mechanism while keeping the trigger pulled,thus driving a fastener each time the work is contacted .
All pneumatic tools are subject to recoil when driving fasteners.The tool may bounce,releasing the trip , and if unintentionally allowed to recontact the work surface with the trigger still actuated (finger still holding trigger pulled) an unwanted second fastener will be driven.