Maintenance skills for high speed nail making machines

To make high-speed nail machine play its due performance, extend its service life, scientific maintenance is essential.Today, for everyone to popularize the high-speed nail machine 19 maintenance skills:

1. The cables for the power supply switch and main line switch configured for the machine tool must meet the power requirements.
2. Ensure that no less than the phase conductor section of the protection of the connection wire firmly connected to the machine tool PE terminal.
3. Before connecting to the power supply, check whether the electrical system is in good condition and pay attention to whether the motor is damp.
4. The oil in the tank should be filled to the oil mark and, if necessary, inspected and refilled.
5. Each switch and operating handle should be flexible, smooth and easy to use.Check their movements.
6. For lubrication points, oil types and corresponding oil levels, see Lubrication Signage.
7. Check the motor, gear and other parts for abnormal noise.
8. Check the lubrication of each sliding component. When the machine is working, check the working state of the oil pump to ensure that it works normally.
9. Check that the protective cover and safety guard are in good condition.
10. Check belt tightness, if the belt wear is too serious should be adjusted and replaced.
11. It is strictly forbidden to place any tools on the plane above the machine.
12. Timely handling of scissors under the belt chip plate at the iron chip and nail mold between the guide rail dust.
13. No cleaning work is allowed before shutdown.
14. Put all parts of the machine back in position.
15. Check whether the belt is damaged and tight, timely replacement and repair.
16. Check the wear of the cutting tool and the mold. If the wear is serious, please change it in time.
17. Check the amount of lubricant used and contamination, and add and replace if necessary.
18. Clean up the debris in the nozzle to avoid blockage.
19. Before coming off work or leaving the machine, the main power switch should be closed, and clean up the machine, remove iron scrap.