What faults will occur in the process of nail making?

What faults will occur in the process of nail making?How should we operate and exclude.

Firstly, the flywheel of the nail making machine can be moved by hand to check whether the moving parts are flexible and reliable. After making sure that there is no problem, start the machine and wait for the normal operation of the machine, then pull the incoming wire handle to make nails, and stop the incoming wire before stopping the machine.

Second, in the process of operation, we should always pay attention to the nail machine parts of the friction temperature changes and abnormal sound. If any abnormality is found, we should control the nailing machine’s incoming line and stop the incoming line.

Third, if there is no knife mark on the nail body, the whole clamping line slider can adjust the knife mark of the incoming line to the nail cap or the nail point at the front and back position of the clamping line slide seat, so as to achieve the purpose of the knife mark of the nail body.

Fourthly, after making nails, we should pay attention to whether the nail cap, nail body and nail tip are in accordance with the regulations, and eliminate different faults. Nail making machine failure is often caused by a variety of reasons , the operator and equipment maintenance personnel should be familiar with the nail-making machine performance and working principle. At the same time can also consult nail making machine manufacturers, in order to better eliminate the defects of nails, so that the machine is in a normal working state.